if the amps are setup right to begin with, your inputs should match the design, thus already calculated for THAT level. if you need to bring that level down in order to get to the design level, something is wrong. bad cable or bad personnel activating/splicing. IF you have the correct level out of the 1st amp, it all should fall into place.
>We are having a problem with setting up the forward levels. Some are under the idea that you should calculate your min. input levels to the first chip, pad for that, then pad each output leg to make up the diffrence.
> The S.A. manual says to only use the main input pad to get desired output levels. And leave the IS pads and output pads as they originaly came from the factory?
> Can anyone shed any light on this problem?
> P.S. this is the latest GainMaker series.
Re:P.S.
Member #: 170
Registered: 1996-2001
Posted:
4051
Name:
Mark Connelly
Name:
Mark Connelly
Company:
Adapt or Die
Occupation:
Retired
Location:
Cincinnati Ohio
Personal:
There is 1 reply to this message
