Carl,
Thanks for the reply. Can you define the formula (our system is 5 deep). How I understood it is, from our reference (the node), I resweep that same port @ the node and my min/max on the average .6 then I just add .5 to that for the spec max 1.1 for my fist amp out that i'm shooting for. Then add .5 for the second and so on. These spec are hard to acheive, so sometimes I tweak the BDR board (Is this ok?). When sweeping is it ok to tweak with the BDR board? I know what to look for on respones on the sweep such as sucks out, bad cable and etc..
Re: Sweeping & BDR boards
There are 2 replies to this message
