Typically this was used in the Therm position in both the LE's and MB's but if used just after the 19mhz trademade hump showed up you could use them in the MB and save a few for down line. If you wait to long to use them what you end up doing is under or over equalize the return and then you probably won't be able to get it back in spec. providing you use the N/10+2.0 formula. Hope that helps
> Hello. . You posted about an RPC PEAKER and a specific model number. What is an RPC Peaker? is it a new rev gain block? Is it something that we'll be able to incorporate into our existing LEs? If you could tell me more about it please do so, please please.!
>
> >>>Sounds like the typical 19mhz hump that was fixed with a RPC peaker back in 2000. They made a newer version board in the amp that corrected that issue.In 2002 they came up with the 870hmz ergonomic and they used up their surplus boards and instead of fixing the problem before it went out the door they sent it out and told the customer to change their spec. It seems ATT was the only one to my knowledge to hound them about this issue, Thus the JXP-RPC (927703-003-00) was made.
>
Re: Ingress-GI-Please Read
Member #: 18672
Registered: 1996-2001
Posted:
69
Occupation:
Headend Tech
Location:
Oregon
Personal:
Experience:
~34 years
There is 1 reply to this message
