So, you want to align the reverse? Start at the node, you need to optimize the link from the node to the hub or H.E. System engineering should give you carrier level for send and receive.
Now, Go to the first amp out, while your parner stays at the node. Inject your 20 dB (not including test point compensation) into the return in test point on the module(output side). Adjust the output pad so that your partner sees 20 dB (minus T.P. comp) at the return INPUT to the node. Repeat the process at each active, with your partner setting at the active you just left reading signal level. Of course, using an alignment or sweep system like Acterna or Calan is a bit easier. but also more $$$ Good Luck
> Alright, I'm tired of talking to the 'experts'>>>
Re: Reverse path alignment for 'unity gain'
There are 0 replies to this message