Listen bud , if they show it on the print like you are showing, timewarner prints will show an internal on the amp adelphia pretty much just lets you have your own descretion.
>1 is main in 2and 3 are feeder and 4 is ac only 6 is main out but you can use internal toi split 5 and 6
> If you want equal outputs, is it necessary to put one leg on each side? Or the two legs on the map on the same side?
> Thanks
> > C-COR AMPS HAVE 5 LEGS=1 INPUT AND4 OUTPUTS.THEY
> > HAVE 6 PORTS WITH THE TOP RIGHT PORT DEAD. LEGS
> > ARE DETERMINED BY INTERNAL JUMPERS AND OR DCS
> > THAT AFFECT EITHER SIDE OF THE AMP STARTING WITH EQUAL
> > OUTPUTS. A SINGLE WIRE JUMPER CAN DETERMINE TOP
> > OR BOTTOM ON EACH RESPECTIVE SIDE.UNLIKE SA'S YOU
> > HAVE A WIDER CHOICE. REMEMBER,THE JUMPERS ONLY AFFECT
> > THAT SIDE. HOPE THIS HELPS. YES,THIS IS ADELPHIA
> > CHOICE EQUIPMENT! TOO BAD WE'RE OUT OF WORK!!!
> > >
> > > The signal is boosted to booth the main and aux.leg. On one side of the triangle will be your main and the other will be your aux. You can only split the signal on the aux legs with an internal splitter or DC .so two feeds off the some side would be your aux.legs and the single your main .If there is only one cable on each side you need to use the main and one aux W/ a jumper sending rf to the used aux.port.it is good pratice to put trunk on the main.
> > > >
> > > >
> > > > > Thanks for looking. Recently on a job using these maps and C-Core eqpt. The prime provided no manuals, or training on this gear. This is the style of maps. I would like comments from you veteran splicers. We were told by the prime splicing supervisor that it didn't matter what feeder leg ports we used. Is it common sense that the two legs together on the map should stay together on the amp in the field ?
