I used to use a very long drillbit for an electric drill, where the tip was the same size as the shaft of the bit, with a small hole thru one end of the bit.
You drill thru the floor and then thru the insulation below trailer which is about 8-10 inches, and then strip back and run the center conuctor of the drop thru the hole in the bit.
Push the bit thru floor and insulation onto the ground below and push a decent amount of coax thru, and then grab it from the outside with a layup stick of sorts. Now that being said, Jones Intercable use to supply us with anything we needed for installs, and $ 1500 Christmas bonuses in 1978-80 era, and I might assume those days are past.
Re: My latest experience
Member #: 199
Registered: 1996-2001
Posted:
320
Name:
Chris Kramer
Name:
Chris Kramer
Company:
Spectrum Planning, Inc.
Occupation:
VP of Operations
Location:
St. Charles MO.
Experience:
~39 years
There are 0 replies to this message
