Create your free account now! Sign up

Re: MQAM Configuration

Here is the sequence to do pass through, it literrally just passes asi1 mpeg pids out the qam port, so your channel numbers will be by the frequency it is set on, so if you set it at 71, the mpegs will be 71.2, 71.7, 71.9 etc (if the mpeg id's were 2,7,9)

To go into standalone mode, attach to the craft port (serial)

Boot unit, press a key within 2 seconds and it will go into Boot> mode

setbootmode 

0

Reset 

At D9477 MQAM> prompt enter

pidmode 1 0x0 999  

rfoutput 2 off

rfoutput 3 off

rfoutput 4 off


That sets up pass through, I can actually do more than that but without the ability to use set top boxes or transmit psip i'm stuck with those channel numbers and the defaults.
This is CABL.com posting #354888. Tiny Link: cabl.co/mbEua
Posted in reply to: Re: MQAM Configuration by lpraderi
There are 0 replies to this message