My 50s is in for repair and am using a 40s for the time being. I started years ago with a 20s so I know what slow is, but after using a 50 for a few years and going back to the 40, it is a complete slowdown for me.
That is not the story. Doing my daily maintenance on the machine something happened that I had never encountered, during the arc calibration it would just error out saying "left side to far over". After a few retries I stopped and scratched my head, and noticed something with were I was located. Fixed the situation, and the calbrition worked fine. This chump lucked out figuring it out, anyone else want to guess?
chump got stumped
Member #: 73442
Registered: 12/25/2009
Posted:
127
Occupation:
retired 12/16/16
Location:
Boise
Personal:
late 50s
Experience:
~40 years
There is 1 reply to this message
