Create your free account now! Sign up

Re: Sweeping 750 S/A ll / GM


Did I say Module retainer screws?.........NO, i said seizure screws or plugs. You know, the plug thingy that hold the pin connector tight inside the amp housing. It takes a 1/2" nutdriver.

If you had paid attention to what i said, you would also notice that i said "a year or so" after they were put in, not right behind the splicers. They do tend to loosen up after a year or so.

However that was a good point about the strip lines not being cut if running an agc or thermal. I guess i took that for granted they were smart enough to cut those as they put in the agc's or thermal's.
This is CABL.com posting #133480. Tiny Link: cabl.co/mIS4
Posted in reply to: Re: Sweeping 750 S/A ll / GM by Countdown
There is 1 reply to this message
Re: Sweeping 750 S/A ll / GM 19 MHz 8/3/2004 12:14:00 AM