Create your free account now! Sign up

Re: ANTEC 870mhz FWD SWEEP

If these are the same amps im thinking about i swept these amps 7yrs ago in utah to 650-750mhz. one thing i noticed with these amps if you have problems with your sweep response you might want to check your screws that hold the module in place to the housing. I found by turning these screws a hair and i mean a hair that the response changes dramaticly. Another thing i also found was after sweeping an amp with a good sweep response once i closed the lid on the lx the sweep response changed quite a bit so you might want to double check your sweep response after you have swept the lx and the lid is closed.Sometimes if the torque on the lid is not even it will defenitly change your response. Check off the tap while the lid is closed to make sure you dont have a bad test point. The problem is i cant rember if they were texscan amps or antec amps have not worked with these amps alot!! Well i hope this helps good luck!
This is CABL.com posting #125864. Tiny Link: cabl.co/mGUe
Posted in reply to: ANTEC 870mhz FWD SWEEP by travlnRFman
There are 0 replies to this message